Polystyrene adhesive

STYRO-KLEBER is ideal for the permanent bonding of all types of expanded or extruded polystyrene as well as fibrous quilted sheet materials such as glass wool, mineral wool, etc., which require instant adhesive strength. They are processed by one-sided gluing for temporary assembly or two-sided gluing for permanent adhesive applications.

 

Product advantages

  • Excellent adhesive properties
  • Heat resistant up to 106 ° C.
  • Fast drying with suffi ciently long
  • processing time
  • Optimal processing properties against
  • coating adhesive
  • It requires signifi cantly less glue,
  • thus less cost
  • Gentle on milling tools, by thinner
  • adhesive layer

 

 

DIRECTIONS FOR USE

This product is designed to be applied to two surfaces to be bonded together. Make sure that surfaces are clean, dry and free from dirt, dust, oil,loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between 60 degrees F - 80 degrees F (16 degrees C - 27 degrees C).

Use with adequate ventilation. When possible we recommend shaking the canister well before using. Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.

Prior to use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates. Spray about 10-20 cm (4” – 8”) away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.

Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.

If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. Do not use a pin on the spray tip orifice.

Portal Milling Machines

Milling Tools

Used Machines

Equipment

DE
Instagram Facebook